Miller Spectrum 375 Plasma Cutter (907532)

Miller Spectrum 375 Plasma Cutter (907532)

$975.00

Add to cart

On sale!

 

The Miller Spectrum 375 Plasma Cutter with XT30C Torch cuts 3/8" mild steel and has dual 115/230 volt input ower capability.Miller Spectrum 375 plasma cutter now features the new XT30C plasma torch

 

More details

The Miller Spectrum 375 Plasma Cutter with XT30C Torch cuts 3/8" mild steel and has dual 115/230 volt input ower capability.Miller Spectrum 375 plasma cutter now features the new XT30C plasma torch


 


  • Applications Processes
    Auto Body
    Maintenance
    Fabrication
    Light Construction
    HVAC Ductwork
    Prototyping

    Features:
  • Pilot Arc Controller increases cutting capabilities and speeds, and improves tip life.
  • Capable of Drag Cutting quality cut (approx. 7 IPM) at 3/8" mild steel. Stand Off quality cut (approx. 7 IPM) at 1/2" mild steel.
  • Power Factor Correction expands operator's work area via extension cords with less nuisance tripping than previous model. Allows the Spectrum 375 CutMate to use up to 50 ft of 12 AWG extension cord on 115V, 20 Amp service and to draw 20% less current when cutting and than the previous model.
  • Increased Line Voltage Compensation regulates input power to a fixed value as line voltage droops or spikes by +/- 15% for steadier cuts and cleaner ending cuts.
  • Advanced Flashing LED indicators for pressure, power, cup and temperature allow faster troubleshooting eliminating unnecessary downtime.
  • Ergonomic design of XT30C torch with increased comfort, safety trigger, and improved flexible cable.
  • Dual input voltage located in back of units allows either 115 or 230 VAC input power and provides patented protection in case of incorrect switch position. Unit provides full cutting capacity when powered by most engine-driven welders with 240 VAC auxiliary receptacles.
  • Compatible with engine-driven welders capable of cutting 3/8 to 1/2 in mild steel when powered by a Miller engine-driven welder with 6000 watts, 240 V receptacle.
  • Starts without high-frequency so it will not interfere with controls or computers.
  • Postflow cooling circuit extends the life of the consumables and torch by cooling them with postflow air after the trigger is released.
  • Consumables storage compartment provides convenient access to consumables and parts.
  • Gas/air filter/regulator inside the power source provides added protection during transportation. Standard air connection on back panel for easy gas or air hookup.
  • LVC Line Voltage Compensation - Keeps output of the power source constant regardless of fluctuation in input power +/- 10%.


 

  • Comes Complete With:
  • Spectrum  375 Plasma Cutter
  • XT30C hand-held torch with 20 ft cable.
  • 20 ft HEAVY-DUTY work cable with clamp
  • Extra consumables (3 electrodes, 3 tips, and 1 air fitting)
  • 10 ft power cord with 115 VAC, 20 A plug

 

  • Easy-to-connect, built-in gas/air filter and regulator with extra protection.

 

Specs :http://www.millerwelds.com/pdf/spec_sheets/PC9-1.pdf

No customer comments for the moment.

Only registered users can post a new comment.

Cart  

No products

Shipping $0.00
Total $0.00

Cart Check out